Rain Delay; Water Usage Correction; Automatic "Stop Irrigation Plan" Function - Bresser HomGar 7510100 Instruction Manual

RAIN DELAY

Rain delay allows you to pause irrigation plans for 24 hours.
You can make this setting in two places in the app:
Plan overview page
On the plan overview page, you will find an overview of all
irrigation plans. Tap the slider of the corresponding water
timer to activate the "rain delay." This means that all irrigation
plans for the water timer connection are paused for 24
hours.
Tap "..." at the top right to turn rain delay on or off for all
irrigation plans.
Sub-device plan page
On the plan page of the sub-device, you will find all irrigation
plans of the corresponding water timer connection. Tap the
slider to turn on "Rain Delay". This means that all irrigation
plans for the water timer connection are paused for 24
hours.
18

WATER USAGE CORRECTION

The standard flow accuracy of the water timer is: ± 8%.
To increase flow accuracy, you can measure actual water
consumption and compare it with the flow data displayed on
the app. On this basis, you can set a corresponding correction
value with the "Water Usage Correction". Proceed as follows:
On the device page of the corresponding water timer, tap the
settings icon.
On the "Settings" page, tap "Water Usage Correction". Select
a correction value from -20 to 20% and tap the check mark in
the upper right corner to save.
AUTOMATIC "STOP IRRIGATION PLAN"
FUNCTION
ATTENTION: Use automatic "stop irrigation plan" function
based on soil sensor data only under supervision to manually
interrupt the water supply in the event of any malfunctions.
With the automatic "Stop irrigation plan" function, you can set
a soil moisture value that should not be exceeded. If this value
is measured by the soil sensor, irrigation stops automatically,
even if the irrigation plan provides for a longer irrigation pe-
riod.