Fire Warning This active seating system complies with all UK fire safety standards. In order to reduce the risk of fire: DO NOT SMOKE - Smoking will contaminate the product and is NOT permitted around or on the seat system. This is a common cause of fatal fires.
IMPORTANT SAFEGUARDS READ ALL INSTRUCTIONS BEFORE USING DANGER - To reduce risk of electrocution Always unplug this product immediately after using. Do not use while bathing Do not place or store product where it can fall or be pulled onto a tub or sink. Do not place in or drop into water or other liquid.
Introduction This manual should be used for initial setup of the system and for reference purposes. Product Description The Prelude Seating System is an alternating seat cushion system used in the prevention and treatment of pressure ulcers. By using the established principles of alternating therapy the Prelude Seating System offers patients a comfortable and relaxing support which can both prevent skin breakdown and enhance healing.
Installation Unpacking The pump and seat cushion are packed separately to secure the content. When unpacking the pump unit and seat cushion, check for any damage which may have occurred during transit. Please report any damages to Park House Healthcare as soon as practical and remove the system from use. Setting up Place the pump at the foot of the chair.
Product Functions Transport Mode If required, disconnect the hoses from the pump and join together. The cushion will equalise and retain seat pressure once the pump has been shut off. Infection Control Should the seat become infected then please refer to our disinfection protocol for appropriate cleaning procedures. Support Setting It is important to follow the correct support setting procedure to ensure the patient receives adequate support (lift) while achieving maximum pressure relief and comfort.
Cleaning The following guidelines are suggested by Park House Healthcare as being suitable infection control procedures. Further information is available upon request. Pump Unit General cleaning may be affected by using a cloth dampened with a mild detergent and water solution. This approach may be followed either by wiping with a sodium hypochlorite solution to a dilution of 1000 ppm or by using an alcoholic wipe.
MAINTENANCE The following chart is a guide on how often the pumps filters should be serviced Every 12 months Every 6 months Every 3 months Low particle density Medium particle density High particle density Ensure that all hoses inside and outside the pump and cushion are kink and split free.
Technical Description Pump Specification Power Supply 230V 50/60Hz 0.05A Fuse Rating T1AL / 250v Cycle time 9.5 minutes (50Hz) 8minutes (60Hz) Dimensions 25.4 x 13 x 9.5 (cm) Weight 1.6kg Modes Alternating Air output 7-9 litres per minute Operation 10°C to 40°C (50°F to 95°F) Temperature Storage -15°C to 50°C (5°F to 122°F)
Warranty Your Park House Healthcare product is warranted to be free of defects in materials and workmanship for one year from date of purchase. This device was built to exacting standards and carefully inspected prior to shipment. This warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the customer.
Page 12
Park House Healthcare Ltd Whitehall 26 Business Park, 1 Heathfield Lane, Birkenshaw, West Yorkshire, BD11 2HW, UK. Tel: 0845 0600 333 Fax: 0845 0600 334 Email: sales@parkhouse-hc.com International Tel: +44 (0)1274 475000 International Fax: +44 (0)1274 475046 International Email: international@parkhouse-hc.com Web: www.parkhoue-hc.com Due to its policy of continued development and...
Need help?
Do you have a question about the Park House Heathcare PRELUDE 1002070001 and is the answer not in the manual?
Questions and answers