Introduction; Circuit Board Diagram - Idex Knight Ultra Micro-Pro UMP 100 Series Instruction Manual

INTRODUCTION

Ultra Micro-Pro UMP-Series warewash systems provide the versatility of probe or probeless detergent control through
advanced microprocessor design. With the capability of controlling up to two products, and the choice of liquid or dry
detergent, virtually any warewash application can be accommodated.
The UMP Series warewash control features simplicity and versatility.
SLIDE SWITCH SETTINGS
• Probe/Probeless Switch:
operation with or without a probe
Door/Conveyor Switch: Sets alarm delay range for
•
probe mode. Sets initial charge timing range for
probeless mode.
• Low/High Range Switch: Used if operating in probe
mode. Selects concentration ranges.
• Low/High Audio Switch: Sets the alarm volume.
On/Off Rinse Limit Switch: When on, stops the rinse
•
pump after 30 seconds.
Page 4 of 12
Allows you to select
CONCENTRATION OR RECHARGE
ALARM DELAY OR INITIAL CHARGE
RINSE SPEED
RINSE DELAY
POTENTIOMETER SETTINGS
• Concentration or Recharge Pot: In "probe mode" sets
detergent concentration strength. In "probeless mode"
sets the pump time necessary to recharge the
detergent concentration.
• Alarm Delay or Initial Charge Pot: In "probe mode"
sets the time before the alarm sounds if the probe
senses low detergent concentration. In "probeless
mode" sets the pump time necessary to initially
charge the detergent concentration.
Rinse Speed Pot: Adjust the speed at which the rinse
•
pump runs.
Rinse Delay Pot: Delays the rinse pump from
•
0 to 14 seconds.
0901082 Rev: D (08/08)