Installation sequence
Connecting the plug-in attachment
WAGO BACnet/IP gateway
The plug-in attachment (standard delivery) must be
plugged in.
Do not connect the plug-in attachment until the CAN
bus cable has been connected.
If the gateway is at the beginning or end of the CAN bus:
A
Fig. 10
Plug-in attachment with terminator (standard deliv-
A
ery)
If the gateway is not at the beginning or end of the CAN bus:
Plug in the plug-in attachment without the terminator.
Use the plug-in attachment for looping through the
CAN bus.
18