Set Up & Use; Electrical Requirements; Installation Guide - Haier HRT Series User Manual

Frost-free top mount refrigerator/freezer
Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT SAFETY INSTRUCTIONS
DO NOT PLACE FINGERS OR HAND ON THE AUTOMATIC ICE MAKING MECHANISM WHILE THE
REFRIGERATOR IS PLUGGED IN. THIS WILL HELP PROTECT YOU FROM POSSIBLE INJURY AS WELL
AS PREVENT INTERFERENCE WITH MOVING PARTS OF THE EJECTOR MECHANISM AND THE
SAVE THESE INSTRUCTIONS

ELECTRICAL REQUIREMENTS

Make sure there is a suitable power outlet. 115 Volt, 15 Amp, 3-prong (grounded) power outlet with

proper grounding to power the refrigerator.
Avoid the use of 3-prong adapters or cutting off the third grounding prong in order to accommodate

a 2-prong outlet. This is a dangerous practice since it provides no effective grounding for the
refrigerator and may result in death, fire or electrical shock.
USE OF EXTENSION CORDS - POTENTIAL SAFETY HAZARD
Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it

is necessary to use an extensions cord, use only a 3-wire extension cord that has a 3-prong grounding
plug and a 3-prong outlet that will accept the plug. The marked rating of the extension cord must be
equal to or greater than the electrical rating of the appliance.
Do not use an extension cord longer than 12 ft.

Failure to follow these instructions may result in death, fire or electrical shock.


INSTALLATION GUIDE

INSTALLATION LIMITATIONS
Select a suitable location for the refrigerator on a hard, even surface away from direct sunlight or heat

source, e.g. radiators, baseboard heaters, cooking appliances, etc. Any floor unevenness should be
corrected with the leveling legs located on the front bottom corners of the refrigerator.
UNPACKING YOUR REFRIGERATOR
1. Remove all packaging material. This includes the corrugated base and all adhesive tape holding the
refrigerator accessories inside and outside. Retain foam block between doors if door swing reversal is
required.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
refrigerator.
3. If your refrigerator comes with a snack pan, remove the blue adhesive tape from the rear of the pan.
The pan will not slide in and out without removing the tape.
CAUTION
HEATING ELEMENT THAT RELEASES THE CUBES.
WARNING
ELECTRICAL REQUIREMENT - SHOCK HAZARD
WARNING
PAGE 4 ● SET UP & USE
 

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hrt18rcww

Table of Contents