Faults And What To Do About Them - Bosch WNG2540KGR Instruction Manual And Installation Instructions

Faults and what to do about them

en
Faults and what to do about them
Faults
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The programme will not
start.
The programme has
started and the drum is
rotating, but the drum is
not filling with water.
48
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
~~~ (Rinse hold = no final drain) is activated (depending on the
■
model). Continue the programme by selecting Στύψιμο (Spin)/Άντληση
(Drain) and pressing Έναρξη/Προσθήκη ρούχων (Start/Reload).
The temperature in drum is too high to open the door.
■
The safety function is activated. Stop the programme?
■
The water level in drum is too high.
■
Can the door only be opened by the emergency release?
■
~ "Emergency release" on page 46
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
■
~ "Filter in the water supply is blocked" on page 45
If an additional water filter has been installed (depending on the
Note:
model), check for contaminants and clean if required ~ separate installa-
tion and cleaning instruction for water filter.
Is the supply hose kinked or trapped?
■
Have you touched the Έναρξη/Προσθήκη ρούχων (Start/Reload) but-
■
ton or selected Λήξη σε/Διάρκεια (Finish in/ Time Dry)?
Is the door closed?
■
Childproof lock activated? Deactivate childproof lock.
■
Shop mode activated? If the display shows à•‹ for 5 s after you have
■
switched on the appliance, the appliance is in shop mode. Wait for the dis-
play message à•‹ to disappear. Touch and hold Έναρξη/Προσθήκη
ρούχων (Start/Reload) for at least 5 s. ‹"" will appear in the display
panel. Turn the programme selector to Off. Now you already turned off the
shop mode. You can use the appliance now as usual.
Not a fault – Some programme specifically detect and weigh the load after the
programme has started in order to calculate the optimum amount of water for
washing. The drum will then start filling with water.