Table of Contents
Advertisement
aus Troubleshooting
Fault
Appliance stops dur-
ing the programme or
cuts out.
All LEDs lit up or
flashing.
Fault
Appliance door can-
not be closed.
Lid on the detergent
dispenser cannot be
closed.
Fault
Filling valves making
knocking noises.
Knocking or rattling
noise.
56
Cause and troubleshooting
Arrange the tableware so that no parts project bey-
▶
ond the basket and prevent the appliance door
from closing properly.
Electronics have detected a fault.
Press the main switch button for approx.
1.
4 seconds.
→ "Controls", Page 17
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
‒
the fuse box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
‒
mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 60
Cause and troubleshooting
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.
Check whether the appliance has been installed
▶
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
Remove detergent residue.
▶
Cause and troubleshooting
Caused by the domestic installation. No appliance
fault present. Does not affect functioning of the appli-
ance.
Can only be remedied in the domestic installation.
▶
Spray arm is striking tableware.
Arrange tableware so that the spray arms do not
▶
strike tableware.
Advertisement
Table of Contents
