Table of Contents
Advertisement
Fault
Plastic parts are dis-
coloured.
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
Irreversible clouding
of glassware.
Rust spots on cutlery. Cutlery is not sufficiently rust-resistant. Knife blades
Cause and troubleshooting
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
Only remove large remnants of food and do not
▶
prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Amount of rinse aid to be dispensed is set too high.
Set the rinse aid system to a lower setting.
▶
No rinse aid has been added.
→ "Adding rinse aid", Page 28
▶
Detergent residue is present in the final rinse. Lid of
the detergent dispenser is blocked by tableware items
and will not open fully.
Arrange tableware in the top basket tableware so
1.
the tab collecting tray is not obstructed by table-
ware.
→ "Arrange tableware", Page 33
Items of tableware are blocking the dispenser lid.
Do not place tableware or fragrance dispensers in
2.
the tablet collecting tray.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
Only remove large remnants of food and do not
▶
prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Glasses are not dishwasher-proof, only suitable for
dishwashers.
Use dishwasher-proof glasses.
▶
Glasses are usually only suitable for use in a dish-
washer, i.e. long-term wear or long-term changes
must be expected.
Avoid a lengthy steam phase (standing time after
▶
wash cycle ends).
Use a programme with a lower temperature.
▶
Use detergent with a glass protection component.
▶
are often more severely affected.
Use rust-resistant tableware.
▶
Troubleshooting aus
53
Advertisement
Table of Contents
