Table of Contents
Advertisement
Fault
Refill indicator for
rinse aid does not
light up.
Fault
Water is left in the ap-
pliance at the end of
the programme.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Programme starts
automatically.
Appliance stops dur-
ing the programme or
cuts out.
Cause and troubleshooting
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 43.
1.
Clean the Wastewater pump → Page 58.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 36
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until programme ended.
→ "Terminate programme", Page 36
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
Check whether the rear panel of the appliance is
▶
being pressed in by a socket or hose holder that
has not been removed.
Troubleshooting aus
55
Advertisement
Table of Contents
