Table of Contents
Advertisement
Fault
Detergent residue in
the appliance
Water marks on
plastic parts.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Cause and troubleshooting
Lid of the detergent dispenser is blocked by items of
tableware parts and will not open.
Arrange tableware in the top basket tableware so
1.
the tab collecting tray is not obstructed by table-
ware.
→ "Arrange tableware", Page 33
Items of tableware are blocking the dispenser lid.
Do not place tableware or fragrance dispensers in
2.
the tablet collecting tray.
The lid of the detergent dispenser is blocked by the
tab and will not open.
Position the tab in the detergent dispenser cross-
▶
wise, not vertically.
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
Select a more intensive Programme or use Powder
▶
detergent.
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
Change your detergent → Page 29.
▶
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arrange tableware", Page 33
Use rinse aid.
▶
→ "Rinse aid", Page 28
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent → Page 29.
▶
Clean the appliance mechanically.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent → Page 29.
▶
Clean the appliance mechanically.
▶
Too little detergent is being used.
Increase the amount of detergent used or change
▶
Detergent → Page 29.
Troubleshooting aus
51
Advertisement
Table of Contents
