Table of Contents
Advertisement
water softener is removed after rinsing
operation, your machine resumes
operation at drying cycle after keeping
silent for a while.
Cancelling (Resetting) the
program
With the door closed, press the Start/
Pause/Cancel button for 3 seconds. Display
shows 0:01 after a 3 - 2 - 1 countdown.
Wait for discharge to complete. The
discharge is completed within 2 minutes
and your machine will sound an audible
warning when it is completed.
Detergent or rinse aid may remain
inside the machine and/or the dishes
being washed as per the step of the
program you have cancelled.
Low Salt Warning indicator (
Check the low salt warning indicator on the
display to determine if the softening salt
available in your machine is adequate. You
shall add salt to the salt compartment when
the low salt warning indicator on the display
starts to illuminate.
Setting of water hardness level is
described in the Water Softening
System section.
Low Rinse Aid Warning indicator
( )
Check the low rinse aid warning indicator
on the display to determine if the rinse aid
available in your machine is adequate.
You shall add rinse aid to the rinse aid
compartment when the low rinse aid
warning indicator on the display starts to
illuminate.
Setting the Rinse aid Amount
1. Press the On/Off key and P2 program
key simultaneously for 3 seconds and
enter the Settings menu after turning
your machine on with On/Off key,
depending on the model you may enter
the Settings Menu by pressing the P3
key for 3 seconds.
2. Move to "P" position on the screen by
pressing the P2 key.
3. Set to a proper level by selecting one
of the "P:0","P:1","P:2","P:3" or "P:4"
positions with the P3 program key.
4. To save, exit the settings menu by
pressing on/off key of your machine
for 3 seconds. Your settings shall be
saved automatically.
Applies no rinse aid in P:0 position
)
during washing program.
Applies 1 dose of rinse aid in P:1 position.
Applies 2 dose of rinse aid in P:2 position.
Applies 3 dose of rinse aid in P:3 position.
Applies 4 dose of rinse aid in P:4 position.
End of programme
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your
dishes will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.
35/EN
Advertisement
Table of Contents
