Table of Contents
Advertisement
Operating the product
Starting of the program
Close the door to start your machine after
selecting the program and additional
functions.
C
Machine softens the water as
per the hardness of the mains
water. The washing period may
change while the program is
being executed depending on
the room temperature, mains
water temperature and the
amount of dishes.
C
Care to avoid opening of the
door while the machine is being
operated. Be careful as steam
may come out when you open
the door of the machine.
C
To ensure that the water
remaining on the dishes and
inside the machine is completely
drained and that the water
softener is removed after
rinsing operation, your machine
resumes operation at drying
cycle after keeping silent for a
while.
Cancelling (Resetting) the
program
With the door closed, press the Start/
Pause/Cancel button for 3 seconds. Display
shows 0:01 after a 3 - 2 - 1 countdown. Wait
for discharge to complete. The discharge
is completed within 2 minutes and your
machine will sound an audible warning
when it is completed.
C
Detergent or rinse aid may
remain inside the machine and/
or the dishes being washed as
per the step of the program you
have cancelled.
/
Low Salt Warning indicator (
)
Check the low salt warning indicator on the
display to determine if the softening salt
available in your machine is adequate. You
shall add salt to the salt compartment when
the low salt warning indicator on the display
starts to illuminate.
C
Setting of water hardness
level is described in the Water
Softening System section.
Low Rinse Aid Warning
indicator ( )
Check the low rinse aid warning indicator
on the display to determine if the rinse
aid available in your machine is adequate.
You shall add rinse aid to the rinse aid
compartment when the low rinse aid
warning indicator on the display starts to
illuminate.
Setting the Rinse aid
Amount
1.
When the door is closed, after turning
on your machine with the On/Off
button, enter the Sub-Menu by
pressing the On-Off and P2 program
buttons simultaneously for 3 seconds.
2. Go to "P" position on the display by
pressing the P2 button.
3. Set it to the appropriate
level by selecting one of the
"P:0","P:1","P:2","P:3" or "P:4" positions
with the P3 program button.
4. Exit the settings menu by pressing
the On/Off button for 3 seconds. Your
settings will be saved automatically.
35 / 44 EN
Advertisement
Table of Contents
