Ametek POWER PRO FERRO 80 Series Owner's Manual page 12

193111-050
INITIAL SET-UP & DESCRIPTION
Charger Control
The Control has an on board microcontroller to
monitor and control the charging process. The
-to-date status of the charge cycle can be easily
monitored by watching the status of the four LED's,
charge in progress, 80% charged, charge complete,
and equalize. The Control utilizes a patented
pt/dv/dt charge termination technique which elimi-
nates excessive gassing by returning approximately
107% of the amp-hours removed from the battery.
All front panel information (including operation
3-2
instructions) is back printed on a polycarbonate
overlay which is resistant to damage from oils, gas-
oline, and frequent operator handling. The Control
is "matched" to the output voltage of the charger by
up
means of a printed circuit board mounted DIP
switch. Features of the Control include Auto Start/
Stop, Auto/Manual Equalize, Manual Stop, Backup
Timer Protection, pt/dv/dt Termination Method,
2.37 V/C & 2.45 V/C 80% Point, 48 Hour Refresh,
and AC Power Fail Recovery.
November 17, 2020