Fcc - HP P Class 450/500/550/600/650/700/750 Supplementary Manual

FCC

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules and the Canadian Department of
Communications. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
NOTE You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Hewlett-Packard's FCC Compliance Tests were conducted with HP-supported
peripheral devices and HP shielded cables, such as those you received with your system.
Changes or modifications not expressly approved by Hewlett-Packard could void the
user's authority to operate the equipment.
Notice for Japan (Class A)
Appendix A
Regulatory Information and Warranty
Regulatory Information
29