Table of Contents
Advertisement
User Modes:
Mode Name /Discription
Change Celsius (
C) to Fahrenheit (
0
Disable/Enable Heat Options
on product and remote control
Disable/Enable Heat Options
on product only
Optimal Product Setup
When the product is switched on, the default brightness setting is F3, with all the effects operating.
However, for optimal effect if the product is in a bright room, it is recommended that the toplights
are switched off. If the product is operating in a darker room, it is recommended that the toplights
are switched on, and the brightness effect is changed to Pulsing.
Please note: The product will maintain the most recent brightness settings if switched to standby.
If the product is unplugged at the wall, it will revert to factory setting.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the fan heater to prevent damage due to overheating.
This can happen if the heat outlet was restricted in any way. If the cut-out operates, unplug the
heater from the socket outlet and allow approximately 10 minutes before reconnecting. Before
switching the heater back on remove any obstruction that may be restricting the heat outlet, then
continue normal operation.
Action (Actions cannot be input by remote control)
Press both Temp down (
F)
0
and display flashes. (To revert back to Celsius repeat this action)
Hold both Heat Cycle ( ) and Temp Up (
when the heater has been disabled the display will read "--" and beep 1
time. To enble heat repeat this action.
Hold both Flame cycle (
seconds, when the heater has been disabled the product will beep. This will
disable heat control functions on the product only. To enble heat repeat this
action.Note: the remote control will still be able to operate heat functions.
) and Temp up (
) on the unit and hold until beep is heard
), on the product, for 5 seconds,
) and Heat cycle ( ), on the product, for 5
11
Advertisement
Table of Contents
