Table of Contents
Advertisement
A
B
F
H
C
Operating Instructions (On Board Controls)- See Figure 9
Icon
1
2
3
4
5
6
1
10
Fig. 7
D
E
J
G
Description
Press Once to turn the product 'ON'.
Press a second time to put the product into 'STANDBY'
(When returning from 'STANDBY' mode the product will return to previous
settings unless the product has been unplugged, in which case it will reset to
factory settings)
'FLAME EFFECT' button this button will cycle trhough the settings 'F0', 'F1',
'F2', 'F3', 'P'.
Press to turn ON/OFF the Top light illuminating the fuel bed.
'HEAT' switch cycles the unit sequentially through the 4 settings: LOW HEAT,
HIGH HEAT, COOL BLOW and OFF. The heat setting will be indicated by an
icon in the display. See table on previous page for further details.
Press multiple times to increase the heater temperature in 1
The highest temperature that can be set 31
When High Heat is selected, the letters 'HH' appear in the display, this
means the heat will remain ON continusously and is not controlled by the
thermostat.
Press multiple times to lower the heater temperature in 1
lowest temperature that can be set is18
2
3
4
Caution: The remote handset requires a cell battery (CR2032)
to operate. This is supplied in a small zip bag with the
handset. Locate the battery compartment on the back of the
handset. Remove the screw using a Philips screwdriver from
the battery compartment door (keeping it safe to be refit-
ted later). Remove the battery compartment door. Insert the
CR2032 battery ensuring it is installed the correct
orientation. Replace the battery compartment door and refit
and tighten the screw. Do not over tighten. The use of this
screw is intended to add extra child protection to your
handset.
0
C.
0
C.
5
6
Fig. 8
0
C increments.
0
C increments. The
Fig. 9
Advertisement
Table of Contents
