Table of Contents
Advertisement
2.10-2 Remote Power On/Off Switches: JSW1/JSW2
Connect to a 2-pin push button switch. If Instant-on is Enabled, every time
the switch is shorted by pushing it once, the power supply will change its
status from OFF to ON. If Instant-on is Disabled: During ON stage, push
once and the system goes to sleep mode: pushing it more than 4 seconds
will change its status from ON to OFF. If you want to change the setup,
you could go to the BIOS Power Management Setup. This is used for ATX
type power supply.
Note: The two switches are provided by the mainboard for your
convenience, so you can use any of them. The two switches have
the same function.
JSW1
2-31
JSW2
Advertisement
Table of Contents
