Table of Contents
Advertisement
6
FRYBABY3 Compact Burn-in Generator
Speaker Cables
Connect the supplied binding post adapters to the RCA outputs (red and white). Red
binding post is hot, black is return (also connected to grounding post).
Headphones
Use the supplied 3.5mm stereo jack adapter to connect your headphones. Set output to
ON.
Phonostage, Linestage, Amplifier
Amplification electronics are burned in using voltage mode. Connect the outputs to the
inputs on your phonostage (you'll need an interconnect). Set the output amplitude to
either MC or MM, depending on the gain of your phonostage. This sets the burn-in
signal to the correct amplitude and equalization. For linestages or other types of
amplifiers, use the ON level output. Amplifiers must be powered on in order for burn-in
to take effect.
Troubleshooting
If the LED is not lit, check power supply and rotary switch.
Advertisement
Table of Contents
