Table of Contents
Advertisement
knob left moves the bottom left; turning right moves the bottom right. Make an
adjustment and then run a
sample. Continue until it
is corrected.
PAPER CREASERS
There are 3 paper creasers on the back of the PH-1 which can be used when you want
to perform a cross fold on a second machine. A crease makes the fold better. To see
these more clearly, remove the fold plates in the back.
In this example, the upper one is set to crease the paper. It would place a crease in the
middle of the paper to make a cross fold in half. Note that the side wheels are tight
against the creaser, directly above 2 other wheels below them. A crease is made when
the wheels on each side are tight against the crease wheel. The side wheels should be
directly on top of another set of wheels below them. Use an Allen wrench to loosen the
set screws so they can be moved.
To stop creasing, move the side wheels away from the creaser using an Allen wrench to
loosen the set screws. If the side wheels are not tight to the creaser. no crease is made.
This is shown with the lower 2 creasers.
Page
8
Paperfolder.com PH-1 User manual
Advertisement
Table of Contents
