HP Kayak XA Supplementary Manual page 5

Installing a Dual Processor / Replacing a Processor
HP Kayak XU PC Workstations are supplied with dual processor slots and either
one or two processors installed. Single processor models can be upgraded to
dual processor systems by installing the second processor accessory in the
vacant slot.
The second processor must be a Pentium II processor of the same speed and
level-2 cache memory capacity as the first. It is installed by gently sliding the
processor into the vacant processor connector slot until the two plastic clips at
the sides engage to lock the processor into place.
Every processor that is installed, or replaced, must be accompanied by the
voltage regulator module (VRM) that was supplied with it. Each VRM is specific
to the processor with which it was supplied, and should only be used with that
processor.
The following table explains how to perform supported processor upgrades.
Upgrade
to
1 Add D6527A
350MHz
1
400MHz
1. Switch settings must be changed. Ensure that the latest BIOS version
has been installed.
2. Supplied processor must be removed.
NOTE:
Plastic clips
Bracket pillars
Mini-Tower
PC Workstations
HP Kayak XU PC Workstation
2
350MHz 400M Hz
1
Remove 350MHz
processor
Add 2
Add D6528A
After installation of a second processor, the operating
system must be reinstalled.
HP Kayak XU PC Workstation 1-5
2
2
1
D6528A
1
Heat-sink
1