Stop The Machine; Use The Cord Retainer; Operation Tips; Maintenance - GreenWorks SSA103 Operator's Manual

WARNING
Examine the work area. Remove all stones, sticks, wire,
bones, and other debris that can ricochet because of the
rotating impeller.
7.2

STOP THE MACHINE

1. Release the trigger switch(2).
WARNING
Wait until the impeller fully stops before you start the
machine again. Do not quickly turn the machine off and on.
WARNING
Pull the plug after you complete the work.
7.3

USE THE CORD RETAINER

1
Do not plug the extension cable into the outlet until it has
been connected to the cord retainer and plugged into the
machine.
1. Fold the extension cord to form a tight loop near the
retainer.
2. Push the loop through the bottom hole in the retainer.
3. Move the loop over the retaining clip, and pull until the
cable is secured.
7.4

OPERATION TIPS

NOTE
1
English
• Start the snow shovel by following the Starting
Instructions. The depth and weight of the snow will
determine the forward speed.
• Push the snow shovel forward so that it rides on the
scraper.
• Verify that the power cord is attached to the cord retainer.
The power cord should trail to the side of the operator.
8

MAINTENANCE

Disconnect the extension cord before maintenance.
Use only approved replacement parts.
Do not use strong solvents or detergents on the plastic
housing or components.
8.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the remaining snow on the machine with a brush.
8.2

REPLACE THE SCRAPER

Use only approved replacement scrapers.
Wear heavy gloves or wind cloth around the impeller when
you touch the impeller.
9
WARNING
CAUTION
CAUTION
1
2
2
WARNING
WARNING
EN