5. How to Assemble Failure to follow this instruction may result in fire, electric shock, injury, or malfunction. For after-sales P.07 6. Assembly and Disassembly of service and product maintenance, contact the HUROM Silicone Customer Center. P.08 7. How to Operate When the power plug is damaged, do not repair or dismantle it on your own.
- When extracting only the ingredients with long and the HUROM Customer Center. thin stalks such as water parsley, they may not be Do not move the product body, or disassemble or extracted properly.
4. Precautions before Juicing 3. Power Dial ※ When you prepare juicing ingredients, Turn the dial to the left or right make sure to choose your own proper for operation. i n g r e d i e n t s i f y o u h a v e a n y f o o d allergies.
Page 6
4-1. Multi-screw • A s some ingredients need extra care in trimming, please refer to the preparation guide below. • I f y o u a r e j u i c i n g i n l a r g e q u a n t i t i e s or multiple times, then finely trim the ingredients and repeat the "disassemble and clean after juicing"...
5. How to Assemble ⑤ ①-4 ④-2 ④-4 ⑤ ④ ③ Assemble the bottom of the multi-screw ( ) with the top of the multi-screw ( ) as shown in the figure. Press down the multi-screw set assembled in the chamber. ①-4 Align the hopper [ ] assembly guide mark (...
6. Assembly and Disassembly of Silicone ※ Silicone packings are supposed to be replaced every 6 to 12 months. You can purchase them through our Juice Cap Packing Customer Service Center. (The juicer may leak if the product is not assembled properly.) Extraction Packing After cleaning, firmly insert with the round side outward...
8. When the Screw Stops during Operation 01 Open the hopper cover. ① Pull the lever of the hopper cover to open it. 02 Add the juicing ingredients below the limit mark of the hopper. ① Use soft ingredients by mixing them with others.
9. How to Disassemble and Clean ※ After the product stops operating completely, unplug the power cord with your dry hands. The motor is still slowing down after the appliance is turned off so wait about 3 seconds before separating the chamber set. Separate the chamber set from the product body.
10. Before Requesting Check the following before asking for repair. For follow-up service and any inquiry you may have while using the product, please contact our Customer Center, or Repair homepage at http://www.globalhurom.com Check the manufacturer’s number or the number under the barcode when requesting for follow-up service or parts. 01.
Need help?
Do you have a question about the H310A Series and is the answer not in the manual?
Questions and answers