Subscribe to Our Youtube Channel
Related Manuals for Studer Xcom-LAN
Summary of Contents for Studer Xcom-LAN
- Page 1 Remote communication set for Xtender systems Xcom-LAN Quickguide Copyright © Studer Innotec SA – V 1.2.1 4O9E7...
- Page 2 With one device in the system the termination on the Studer device should be put to T as in "Termi nated". With more than one device in the system all Studer devices should be put to O as in "Open Additional items needed apart from the devices at the end of the communication chain.
- Page 3 Xcom portal. installed! Keep it safe. Register the installation at: https://xcom.studer-innotec.com in order to control it remotely with the Xcom-LAN. n" Insert the Micro SD card into the Xcom-232i Remove the SD card from the PC and insert it into the Xcom-232i.
- Page 4 Please change the If the installation is new and the Micro SD outbound rule for this port. card of the Xcom-LAN/-GSM is empty, it is normal that there are no files on the server. My Xcom-LAN is well-configured and con- To activate the automatic recovery of the nects to the server, but I can’t register it...
- Page 5 LED states LAN gateway LEDs State Indication name colour Always On Power is on and the NPort is booting up. Blinking Indicates an IP conflict, or DHCP or BOOTP server is not responding properly. Ready Always On Power is on and the NPort is functioning normally. Green Blinking The NPort has been located by the NPort Administrator’s Location function.
- Page 6 Installation, commissioning, use and maintenance or repairs whatsoever. Regarding authorized of this device cannot be supervised by Studer modifications and replacements, only gen- Innotec SA. For this reason, we do not accept uine components shall be used.
Need help?
Do you have a question about the Xcom-LAN and is the answer not in the manual?
Questions and answers