Hardware Installation; Caution Of Static Electricity - Boser HS-5210 Manual

Chapter-2

Hardware Installation

This chapter provides the information on how to install the hardware of
HS-5210/5020. At first, please follow up sections 1.3, 2.1 and 2.2 in check the
delivery package and carefully unpacking. Following after, the jumpers setting of
switch, watchdog timer, and the DiskOnChip? address selection.
The CN15 only available of model HS-5210/5020, and CN16 only available of
model HS-5210P/5020P.

2.1 Caution of Static Electricity

The HS-5210/5020 has been well package with an anti-static bag in
protect its sensitive computer components and circuitry from the damage
of static electric discharge.
Note: DO NOT TOUCH THE BOARD OR ANY OTHER SENSITIVE
COMPONENTS WITHOUT ALL NECESSARY ANTI-STATIC
PROTECTION.
You should follow the steps as following to protect the board in against the
static electric discharge whenever you handle the board:
1. Please use a grounding wrist strap on whoever needs to handle the
HS-5210/5020. Well clip the ALLIGATOR clip of the strap to the end of
the shielded wire lead from a grounded object. Please put on and
connect the strap before handle the HS-5210/5020 for harmlessly
discharge any static electricity through the strap.
2. Please use anti-static pad for put any components or parts or tools on
the pad whenever you work on them outside the computer. You may
also in use the anti-static bag instead the pad. Please ask from your
local supplier in help up your necessary parts on anti-static requirement.
7