ECS L4S5A3 Manual page 41

you are going to install a PCI audio add-on card.
SIS-7013 S/W Modem (Enabled)
Enables and disables the onboard modem. Disable this item if you are going
to install an external modem.
SIS-1394 Controller (Disabled)
Enables and disables the onboard 1394 controller.
Press <Esc> to return to the Integrated Peripherals screen.
Onboard SuperIO Device
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
↑ ↓ → ← : Move
Enter : Select
F5:Previous Values
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt request (IRQ) for
onboard serial port 1 (COM1).
Onboard Serial Port 2 (3F8/IRQ3)
This is the default address for devices using serial port 2 if you do not have
any devices plugged into this port disabled is preferred.
UART Mode Select (Normal)
This option is used to select an operating mode for the second serial port.
UR2 Duplex Mode (Half)
In an infrared port mode, this field appears. Full-duplex mode permits simulta-
neous two-direction transmission. Half-duplex mode permits transmission in
one direction only at a time. Select the value required by the IR device con-
nected to the IR port.
Onboard SuperIO Device
[Enabled]
[3F8/IRQ4]
[3F8/IRQ3]
[Normal]
[Half]
[378/IRQ7]
[ECP]
[3]
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults
37
Item Help
Menu Level
F1:General Help
F7:Optimized Defaults