Philips ME5P Service Manual page 70

70 ME5P 15" & 20"
Re-programming Digital DDC IC
Step 1: After initialize alignment box, connecting all cables and
box as shown in Fig. 10
Fig.10
Step 2: Read DDC data from monitor
1. Click icon as shown in Fig. 11 from the tool bar to bring up
the Channels "Configuration Setup" windows as shown in Fig. 12.
2. Select the DDC2Bi as the communication channel.
As shown in Fig. 12.
3. Click OK button to confirm your selection.
4. Click icon (Read EDID function) to read DDC EDID data from
monitor. The EDID codes will display on screen as shown in Fig. 13.
Fig. 13
DDC Instructions
Step 3: Modify DDC data (verify EDID version, week, year)
1. Click
DC 8~12V
Step 4: Modify DDC data (Monitor Serial No.)
1. Click
Fig. 11
Fig. 12
(new function) icon from the tool bar, bring up
Step 1 of 9 as shown in Fig. 14 .
EDID45 DDC application provides the function selection and
text change (select & fill out) from Step 1 to Step 9.
To Printer port
To Monitor
D-sub/DVI cable
Fig. 14
Next , bring up Fig. 15. Then select Digital Signal as below
Fig. 15
Fig. 16