Advertisement
When using on table with HON Interlink electrical system
When using an electrial furnishing, basic precautions should always be followed, including the following:
Read all instructions before using (this furnishing)/
DANGER - To reduce the risk of electric shock.
1. Always unplug this furnishing from the electrical outlet before cleaning.
WARNING
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not
recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never operate the furnishings with the air openings blocked. Keep the air openings free of lint, hair and the like.
7. Never drop or insert any object into any opening.
8. Do not use outdoors.
9. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
10. To disconnect, turn all controls to the off position, then remove plug from outlet.
WARNING
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and ground-
ed in accordance with all local codes and ordinances.
DANGER - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with
a qualifi ed electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify the
plug provided with the product - if it will not fi t the outlet, have a proper outlet installed by a qualifi ed electrician.
b) For a ground, cord-connected product rated less an 15 amperes and intended for use on a nominal 120-volt supply
circuit, the instructions in either (1) or (2)"
1) This product is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug illustrated in
sketch A )see Figure 63.1). A temporary adapter that looks like the adapter illustrated in sketches B and C able to be used
to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded outlet is not available. The tempo-
rary adapter should be used only until a properly grounded outlet (sketch A) can be installed by a qualifi ed electrician. The
green colored rigid ear, lug, or the like extending from the adapter must be connected to a permanent ground such as a
properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw.
2) This product is for use on a nominal 120-volt circuit and has a grounding plug that looks like the plug illustrated in
sketch A (see Figure 63.1). Make sure that the product is connected to an outlet having the same confi guration as the
plug. No adapter should be used with this product.
Grounded
Outlet
Grounding
(A)
Pin
AA200
664-2000E
www.hon.com
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of burns, fi re electric shock or injury to persons:
Risk of Electric Shock - Connect this furnishing to a properly grounded outlet only.
See Grounding Instructions.
GROUNDING INSTRUCTIONS
Grounding methods
Grounded
Outlet Box
(B)
Adapter
Metal
Screws
(C)
Tab for
Ground screws
NOTE:
-
Electrically interconnected tables
shall be mechanically connected.
- Only accessoreis described in the
instructions may be used with these
tables.
7 OF 9
Advertisement
