Spacing Fingers - Grizzly G0479 Manual

5. Check the front edge of the fingers to see if
they are aligned, as shown in Figure 18.
Figure 18. Finger edges aligned.
6.
If an individual finger sticks out beyond the
other fingers, loosen the cap screw(s), wiggle
the finger up or down, retighten and check
finger alignment.
Repeat Steps 3-6 to align additional fingers.
G0578 40" Pan and Box Brake

Spacing Fingers

The fingers can be spaced apart for clearance
when making pans or boxes. This requires
removing one or more of the fingers so that you
can space the others to match the width of your
pan or box.
Tools Needed:
8MM Hex Wrench .............................................. 1
To space the fingers apart:
1. Remove the cap screws from each of the
fingers you decide to remove.
2.
Pull the fingers off the front guide, as shown
in Figure 19, and set them aside.
Note—You may need to mix and match finger
widths to equal the size of your workpiece.
Figure 19. Fingers removed to provide space for
matching fingers with box or pan widths.
3. Align the remaining fingers and tighten the
cap screws. (See Page 18 for alignment
instructions.)
QTY
19