Scanning Film - Canon CanoScan 4400F Quick Start Manual

Scanning Film

Scanning Film
This scanner can scan 35 mm film (film strip or slide). Follow the procedure below when scanning film.
1
Remove the protective
sheet from the
document cover.
When you finish scanning,
put the protective sheet back
by aligning it with the
grooves in the document
cover and sliding it
downward into place.
Always put the protective sheet back when you are not scanning film to protect the
light source in the document cover.
2
Remove the Film Guide
from the document
cover.
Hold the document cover so
that it doesn't close, then
press down and hold the tab
at the Film Guide's top left
and tilt the Film Guide
outward to lift it up.
3
Open the Film Holder.
Pinch the both side of the
Film Holder to open.
6
Calibration Slot
Film Holder