Table of Contents
Advertisement
Scanning Film
You can scan 35 mm film (film strips or slides) with this scanner.
Positioning the Film
Use the following procedures to insert the film into the film guide.
1
Remove the protective sheet from the document cover.
Slide the
protective sheet
up and out to
free it from the
tabs at the top.
Fit the holes at the bottom end of the protective sheet over the posts at the bottom of the document
cover and slide the protective sheet down. Repeat the procedure for the top end.
• Store the protective sheet in a safe place so that it will not get bent or broken.
• Always replace the protective sheet when you are not scanning film to prevent the
light source section from getting scratched.
2
Insert the film into the film guide.
Film Strips
Open the film holder on the film guide for film strips, insert
the strip(s) face down and close the film holder.
• Place a black piece of paper over any gap to
shield the light if you are inserting a film strip
with 5 or fewer frames, or if the edge of a
scanned image appears whitened.
Slides
Place a slide or slides face down in the film guide for slides as
shown in the diagram to the right.
Slide the sheet
up again and
out to free it
from the tabs at
the bottom.
11
Advertisement
Table of Contents
