BOMANN
General repair instructions for refrigerators/freezers
You will find general information on the replacement of certain spare parts. The illustrations and repair
or replacement instructions depend on the type of appliance and may differ slightly from the original
appliance.
Liability for damage is excluded if the repair instructions are not followed correctly.
WARNING!
During repair/maintenance work, the appliance must NOT be connected to the mains
power!
Replacing the door seal
Remove the contents of the appliance and, if
necessary, defrost the appliance. Pay
attention to how the old seal is fixed. Most
gaskets are only plugged in or fixed by small
screws.
Remove the worn gasket rubber by either
removing it from the plug-in device or
loosening the screws. Carefully clean the
appliance door and the groove below the
rubber and remove any adhesive residue.
Depending on how the old sealing rubber was
attached, attach the new rubber. If necessary,
heat the sealing rubber with a hair dryer or hot
water and shape it by hand. Start pressing the
gasket in one corner and then press it all
around the door into the provided socket.
According to the type of appliance, refasten
the screws or plug-in positions on the
appliance.
Continue to check the door seal regularly for
dirt and damage!
Replacing the door handle
Loosen the screw cover caps.
Unscrew the screws.
Remove the door handle.
Door handle assembly is performed in reverse
order.
Replacing the door hinges
Remove the contents of the appliance and the
interior fittings.
Tilt the appliance backwards and block it in
this position to prevent the appliance doors
from sliding out.
1