Operation Panel And Keyboard Keys; Operation Panel Keys - Canon Microfilm Scanner 300 Instruction Manual

1 Negative/Positive key
2 Trimming/Border key
3 Brightness indicator
4 Brightness adjustment keys
5 Print/Error Display
6 Print number setting key
7 Clear/Stop key
8 Start key

Operation panel and keyboard keys

Operation panel keys

This is a summary of the keys on the operation panel.
Three settings are available:
( ) In negative film mode produces positive output from nega-
tive film images.
( ) In positive film mode, produces positive output from posi-
tive images.
( A ) In automatic mode, selects the mode based on the type of
film detected.(©P.33)
Use this key to trim the image to be scanned or to remove the
black border around the image.(©P.34)
Shows the brightness adjusted using the brightness adjustment
key.
Use the or key to adjust brightness of the image manually,
or the use AE key to adjust it automatically. In the DMP mode,
this applies to brightness for printing.
Displays the number of prints (01 to 99) in case of the Reader-
Printer mode. Also displays error message(User and Service
releated).
Use these keys to set the number of prints to make for each
image in the Reader-Printer mode or the DMP mode (©P.11).
Also use them to set various settings or confirm the SCSI ID of
the scanner.
Stops scanning or resets the number of prints. Also defines an
area for trimming, or defines a specified time for the power
saver mode.
When the scanner is connected to the Fileprint 450 and used in
the DMP mode, this key is also used to switch to the cassette
select mode (©P.36).
In the case of the Scanner mode: press this key to start scan-
ning with the "Panel Start" set to on in the application, or to
start scanning in the Reader-Printer mode (©P.11).
In the case of the DMP mode: press this key to start printing.
The Print/Error display stays blinking from the time the key is
pressed until the time scanning begins.
I BEFORE YOU BEGIN ... I
21