Sony MDLP Operating Instructions Manual page 23

Machine Translated by Google
Set the output level
You can set the audio output level of this unit to 3 levels according to the input level of the FM tuner of the car audio .
Normally, the default value (LEVEL2) is used, but switch it if necessary.
To operate with the card remote control
You can perform the same operation by pressing the following buttons.
ENTER
ENTER
ENTER
Notes
• The u button and LIST button do not work while the output level is set. •
When the output level is set to 3, the sound may be distorted or noise may occur depending on the MD you
are listening to . In that case, lower the audio output level of this unit, then turn up the volume of the car
audio and listen at your favorite volume.
1 Press the dial for 2 seconds or longer during MD playback.
2 Shortly press the dial again.
3 Turn the dial to select the output level.
LEVEL1 y LEVEL2 y LEVEL3
4 Finally, press the dial for 2 seconds or longer.
1 Press the ENTER button for 2 seconds or longer during MD playback.
2 Shortly press the ENTER button again.
3 Press the +/- button to select the output level.
4 Finally, press the ENTER button for 2 seconds or longer.
Setting
twenty three