Table of Contents
Advertisement
Machine Translated by Google
Set the transmission frequency
On this unit, listen to MD with an FM tuner. Therefore, if there is an FM broadcast with the same frequency as the frequency set on
this unit (transmitted from this unit to the FM tuner), noise may occur during MD playback. In that case, change the transmission
frequency of this unit. The initial value is 88.3MHz.
To operate with the card remote control
You can perform the same operation by pressing the following buttons.
ENTER
ENTER
Notes •
The u button and LIST button do not work while the transmission frequency is set. •
When you change the transmission frequency of this unit, be sure to change the frequency registered (preset) in the FM tuner.
please.
• You cannot operate the unit with the remote control from the power off state (the display is off).
Press the u button on the display to turn it on.
twenty two
1 During MD playback, dial until the frequency is displayed.
Press for 2 seconds or longer.
2 Turn the dial to select the frequency.
Turn to the right to switch frequencies as follows:
88.3 MHz t 88.5 MHz t 88.7 MHz t 88.9 MHz t 89.1
MHz t 89.3 MHz t 89.5 MHz t 89.7 MHz t 89.9 MHz
t 88.3 MHz
Turn it counterclockwise to display in reverse order.
3 Finally, press the dial for 2 seconds
or longer. 4 Match the reception frequency of the car audio FM tuner
Let me.
1 During MD playback, press the ENTER button for 2 seconds or more until the frequency is displayed.
Press up.
2 Press the +/- button repeatedly to select the frequency.
3 Finally, press the ENTER button for 2 seconds or longer.
4 Adjust the reception frequency of the FM tuner of the car audio.
Advertisement
Table of Contents
