Schenker WORK 15 User Manual page 10

RAID Setup Procedure
1. Go to the operable computer and copy the f6mdflpy-x64 folder
from the location below (D: denotes your DVD drive) on the
Device Drivers & Utilities + User's Manual disc to the USB Flash
drive or external USB hard disk.
• D:\Options\Raid\F6\VMD\f6vmdflpy-x64\
2. Start-up your notebook computer and press F2 to enter the BIOS
and go to the Setup Utility.
3. Select the Advanced menu.
4. Select VMD Mode and select Enabled.
5. Press F10 to Save and Exit and select <Yes>.
6. After the computer restarts press F2 to enter the BIOS again and
go to the Setup Utility.
7. Go to Intel(R) Rapid Storage Technology (in the Advanced
menu) and select Create RAID Volume.
8. You can now setup your RAID volume using the installed SSDs.
9. Select Name and type a name of your choice for your RAID
volume and select <Yes>.
10. Select RAID Level and choose the RAID Level required (see
Table 1 on page 5) and press Enter.
• RAID 0 (Stripe)
• RAID 1 (Mirror)
11. Go to any of the disks listed under Select Disks: and select a
disk name.
12. Click on X to select the disk required.
13. You should select two identical SSDs to form your RAID volume.
14. If you have selected RAID 0 (Stripe) then you can adjust the
Strip Size to your requirements (It is recommended that you set
the "Strip Size" to 128KB).
15. Select Create Volume (make sure you have selected your
disks).
16. The system will list your RAID volume.
6
17. Press F10 to Save and Exit and select <Yes>, however note
below.
• Make sure the Windows OS (DVD) is in the attached DVD
drive or on a USB flash drive and as the computer starts up it
will automatically boot from the Windows OS DVD or USB
flash drive.
18. Click Next > Install Now to continue installing the operating
system as normal (see your Windows documentation if you need
help on installing the Windows OS).
19. Click to select Load Driver when the "Where do you want to
install Windows?" screen appears.
20. Click Browse and browse to the location you copied the files to
on your USB Flash drive or external USB hard disk (X: denotes
your USB Flash drive or external USB hard disk):
• X:\f6vmdflpy-x64 (for Windows 64bit)
21. Select both driver names and click Next.
22. Follow the on-screen instructions to install the Windows
operating system.
23. Install the Windows drivers (see
the Intel® Rapid Storage Technology (IRST) driver.
page 21). Make sure you install