Stihl FSE 60 Instruction Manual page 9

English
Use only the deflector with properly
mounted line limiter blade to ensure that
the mowing lines are automatically
trimmed to the approved length.
To reduce the risk of injury, always
switch off the machine and disconnect
the plug from the power supply before
manually adjusting the nylon line.
Using the unit with over-long nylon
cutting lines reduces the motor's
operating speed. This results in
overheating and damage to the motor.
8
Maintenance and Repairs
To reduce the risk of injury from the
motor starting unintentionally, always
switch off the machine and disconnect
the plug from the power supply before
carrying out any maintenance work on
the machine.
Service the machine regularly.Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and receive technical
information bulletins on engineering
changes.
Use only high quality replacement parts
since there is otherwise a risk of
accidents or damage to the machine. If
you have any questions in this respect,
consult a servicing dealer.
STIHL recommends you use only
original STlHL replacement parts. The
characteristics of these parts are
specifically designed to match your
machine model and meet your
performance requirements.
Never attempt to modify your machine in
any way since this can be extremely
dangerous.
Regularly check that the insulation of the
power cord and plug is in good condition
and shows no signs of ageing
(brittleness).
Electrical components, e.g. power cord,
may only be repaired or replaced by a
qualified electrician.
Use a cloth to clean plastic parts of the
machine. Aggressive cleaning agents
may damage plastics.
Do not spray the machine with water.
Check tightness of mounting screws on
safety devices and cutting tool and
retighten if necessary.
Clean the cooling air inlets in the motor
housing as required.
Store the machine in a safe and dry
place.
FSE 60, FSE 71, FSE 81