Stihl FSE 60 Instruction Manual page 19

English
1
2
Removing Remaining Nylon Line
: Open the mowing head – hold it
steady with one hand and unscrew
the cap (1) counterclockwise.
: Disengage the spool (2), take it out
of the mowing head and remove the
remaining nylon line.
Winding Line Onto Spool
A prewound spool** may be
installed instead of fitting individual
lines.
** see "Special Accessories"
18
3
4
3
: Use green-coded nylon line with a
diameter of 2 mm.
: Cut two 3 m lengths of nylon line
from the replacement reel**
Insert the end of each line (3) in the
holes (4) in the spool.
: Bend the ends of the lines over the
edge of the holes to form a hook.
** see "Special Accessories"
5
: Straighten out the nylon lines and
wind them tightly onto the spool –
one nylon line in each chamber.
: Engage the ends of the nylon lines
in the notches (5).
Assembling the Mowing Head
Check that the compression spring
is installed (see "Mounting the
Mowing Head").
FSE 60, FSE 71, FSE 81
5