Setting The Audio Output - Canon Optura Instruction Manual

Setting the Audio Output

E
When you play back a tape that was recorded in 12 bit mode, you can set the
audio output to play stereo 1 (the original sound), stereo 2 (any new sound,
dubbed to the tape after recording), or mix the balance between the two.
To simply choose stereo1 or stereo2, you do not need to release the fixed level
(skip step number 2 below).
1. Set the camera to VCR mode.
2. Release the fixed level (for audio mixing only).
(see p. 25)
a) Open the VCR menu and point the arrow at MIX SELECT.
b) Select the VARIABLE setting and close the menu.
3. Choose the output.
You can only choose the output using the wireless controller.
a) Press the wireless controller's AUDIO
MONITOR button to display "STEREO1",
"STEREO2", and "MIX", each in turn.
• Your choice is selected approximately 4
seconds after you last pressed the button.
If you choose "MIX" you can go on to mix the
balance.
• Use the
balance.
Notes:
• When you have chosen the output, "STEREO1", "STEREO2", or "MIX" is
shown in the top left of the display. If you turn the power off the output (and
display) is set to "STEREO1"
• You cannot mix the balance without first releasing the fixed level: the camera
will show "FIXED" in the display.
58
MIX SELECT••VARIABLE
cursor keys to choose the mix
MENU
S TER EO 1
S T – 1
AUDIO
MONITOR
S TER EO 2 M I X
S T –2