Sagem myC-3 Technical Documentation Manual page 71

myC-3/ myC-3b
4.31 Tools :
- Cross shaped screwdriver
- Gloves
- Metal dome Jig
Tweezers
4.32 Preliminary operation
This procedure must be performed by a technician with gloves.
1. Remove the battery pack (
2. Remove the back cover (
3. Remove the equipped electronic board (
4.33 Removal procedure :
1. Remove the metal dome (2) of the equipped electronic board (1)
4.34 Placement procedure :
Warning : The metal dome is not reusable, it must be necessarily replaced by a new metal dome,
unless the board is swapped and sent as level 3
1. Replace the new metal dome (2) on the equipped electronic board (1), using the metal dome jig.
2. Place the equipped electronic board in its housing
4.35 Further operations :
1. Replace the equipped electronic board (
2. Replace the back cover (
3. Replace the battery pack (
4. Carry out the radio test
Ref. SCT U38 SSC DTS 0020 – Index A - May 4, 2004
REMOVING / REPLACING THE METAL DOME
Proc sheet 0 01).
Proc sheet 1 01).
Proc sheet 1
Proc sheet 1
Proc sheet 1 01).
Proc sheet 0 01).
(Test Sheet 04).
06).
06).
Proc Sheet 1 04
1/2
Page 5-19