Translation of the original instructions GENERAL INFORMATION - The appliance is intended for PROFESSIONAL use. - The appliance can be used for washing SAFETY PRECAUTIONS surfaces outdoors, whenever pressurised water is required to remove dirt. > WARNINGS - With special optional accessories, it can be used for foaming and sandingblasting, and for • 01WARNING: This appliance is for outdoor washing with a rotary brush for application to...
Page 12
vehicle tyre/tyre valve could be damaged by appliance. • WARNING: Never start the high-pressure the high-pressure jet. The first indication of this is a discoloration of the tyre. Damaged cleaner without first completely unwinding vehicle tyres/tyre valves can be deadly dan- the high-pressure hose.
environments or areas. · Open the water supply. •WARNING: During operation, do not place the machine in areas of poor aeration and WARNING: (symbol) machine not suitable much less cover it. •WARNING: Avoid using the machine in the for connection to the potable water mains. rain and do not direct the jet at it.
manner to the power supply, fit a plug in - The exit of the chimney must be sheltered compliance with the standard of the country to avoid the dripping of rain and to allow the in which the machine is installed; exaust flow.
⑫ - Connect the water supply hose to the snap Rubber hose fitting connection. The hose must have an inside ⑬ Nozzle diameter of at least 13 mm (1/2”). ⑭ Diesel tank - Connect the high pressure hose to the pump’s ⑮...
active for more than 5 minutes. > THERMOSTAT SET ABOVE 100 ° C: USE WARNINGS. At the end of the operation, set the switch to “OFF”. When working with temperatures exceeding 100° C, Activate hand spray gun until device is pressure less. follow these steps: - The working pressure must not exceed the limit of 32 bar.
- Remove water connection. Check the fuel filter periodically and replace if it has - Activate hand spray gun until device is pressure deteriorated or is excessively dirty. less. DESCALING - Lock the trigger gun. The descaling procedure must be carried out periodically Storing the Appliance with specific products.
- Replace every parts doing the operations in the lity for damage to persons or property caused by bad inverse way. installation or incorrect use of the machine. • WARNING: The general checking and combustion WARNING! Failures, such as clogged nozzles, valves regulation must be periodically executed by specialized and mechanism blocked due to limestones, damaged personnel as prescribed by the law.
Page 19
Fault When the main switch is turned on the Cause - The suction and/or delivery valves are worn out. machine does not start - Presence of foreign matters in the valves, which generate bad functioning. Cause - Plug not properly connected. - Air suction.
Page 20
Repair - Replace the seals. - Replace the piston. - Replace the seal. Fault Filtrations of oil from the drains be- tween head and casing Cause - O-ring seals of casing are worn out. Repair - Replace the seals. Fault Turning on the burner switch the boiler does not start Cause - No fuel.
Technical Information Water connection Specifications. Water connection Specifications. Power/Voltage 3000W - 230V - 50Hz Water connection Specifications. Water connection Specifications. Operating Pressure. 150bar/2175psi Water connection Specifications. Water connection Specifications. Water Flow Rate. 660 L/hr Water connection Specifications. Water connection Specifications. Water connection Specifications.
Go to YouTube and search ‘Hyundai Power Products’. Warranty Proof of purchase will be required before you make a warranty claim. Full warranty terms and conditions can be found on the HYUNDAI POWER PRODUCTS website: www.hyundaipowerproducts.co.uk Manual Updates Our manuals are constantly being reviewed and updated. Should you find an error, omission or something unclear, please contact us for assistance.
Product Record Information As soon as you have purchased the machine, we recommend that you fill out the following. If you need to contact an authorised dealer or customer service for information on servicing, you may need to provide the following information. Date Of Purchase:………………………………………………………………………………..
Our friendly aftersales team will be more than happy to help you. Phone Call our team on 01646 687 880 Email aftersales@hyundaipowerproducts.co.uk Online Live Chat Go to www.hyundaipowerproducts.co.uk Post Genpower Ltd, Isaac Way, Pembroke Dock, Pembrokeshire, SA72 4RW. Hyundai Support Website Go to hyundaisupport.co.uk www.hyundaipowerproducts.co.uk...
EN 60335-1 PRODUCT: HOT HIGH-PRESSURE WASHER EU and subsequent modifications, EN 60335-2-79 MACHINE and the standards EN: EN 62233:2008 EN 50581 MODEL: HY155HPW-1 EN 55014-1:2006 +A1:2009+A2:2011 EN 55014-2:2015 EN 61000-3-2:2014. EN 61000-3-3:2013. LpA 73dB(A) 2000/14/EC - 2005/88/EC The A-weighted sound pressure level Lpa in db(A), emitted by the The appliance is defined by no.
Page 28
Isaac Way, London Road Pembroke Dock, UNITED KINGDOM, SA72 4RW T: +44 (0) 1646 687 880 F: +44 (0) 1646 686 198 E: info@hyundaipowerproducts.co.uk www.hyundaipowerproducts.co.uk Imported/Distributed by GENPOWER LTD for The United Kingdom & Ireland Licensed by Hyundai Corporation, Korea...
Need help?
Do you have a question about the HY155HPW-1 and is the answer not in the manual?
Questions and answers