Cell Mounting The Base Station; Wall Mount The Base Station - EnGenius DuraFon Roam BU User Manual

Cell Mounting the Base Station

Using the provided bracket, the Base Station can be attached to a ceiling or wall.
To attach the Base Station to a ceiling or wall using the mounting bracket:
A) Slide the ceiling mount base into the slot of the Base Station.
B) Hold the Base Station with one hand to reach the other hand over the T-Rail sides
of the bracket. Then hook the stationary end of the ceiling mount bracket onto
the T-Rail.
~13~

Wall mount the Base Station

A) Determine where the Base Station will be placed; mark the location for the two
base plate mounting holes on the wall. Use the appropriate drill bit to drill a
hole on each mark (1/3" or 8.1mm diameter; 1" or 26mm deep).
B) Screw the anchors into the holes until they are flush with the wall.
C) Screw the included screws into the anchors.
D) Slide the wall mount base into the slot of the Base Station.
~14~