Operation - Performance Tool M570C Owner's Manual

IMPORTANT SAFETY INFORMATION
13 . Check for damaged parts . Before using any tool, any part that appears dam-
aged should be carefully checked to determine that it will operate properly
and perform its intended function . Check for alignment and binding of mov-
ing parts; any broken parts or mounting fixtures; and any other condition that
may affect proper operation . Any part that is damaged should be properly
repaired or replaced by a qualified technician .
14 . Repairs should only be carried out by a qualified electrician using origi-
nal
so can lead to accidents for the operator . Use of any other parts will void
the warranty . Only use accessories intended for use with this tool . Approved
accessories are available from Performance Tool ® .Use only accessories that
are recommended by the manufacturer for your model . Accessories that may
be suitable for one tool may become hazardous when used on another tool .
15 . Do not operate any tool if under the influence of alcohol or drugs . Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs . If there is any doubt, do not operate any tool .
16 . Maintenance . For your safety, maintenance should be performed regularly by
a qualified technician .
WARNING: This product and its packaging contain a chemical known to the
State of California to cause cancer, birth defects, or other reproductive harm .
WARNING: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may occur .
It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator . Read and understand all of the instructions provided in the instruction
manual of this product, as well as, any other tool (s) used with this product .

OPERATION

Assembly
1 . Attach material hose to the pick-up tube . Place pick-up tube in
source of material to use for blasting .
2 . Attach the air compressor hose to the 1/4 in . NPT (F) plug at the air
inlet on the tool .
Operation
1 . Situate the compressor as far away as possible from sandblasting
area to minimize dust intake .
2 . The air supply must be clean and free of moisture and oil .
3 . Use a compressor than can supply enough air per specifications.
Insufficient air pressure will prevent the tool from operating satisfactorily.
PERFORMANCE TOOLS® replacement parts . Failure to do
3