Table of Contents
Advertisement
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
NOTE:
The replacement palm-rest and keyboard assembly will come with all four battery-screw brackets installed.
Depending on the battery configuration of your computer, slide and remove two of the four battery-screw brackets from
the palm-rest and keyboard assembly to replicate the configuration shown in the images above.
Next steps
1. Install the
system
board.
NOTE:
The system board can be replaced with the following components pre-attached:
● heat sink
● memory
● solid-state drive
2. Install the
side
speakers.
3. Install the
display
board.
4. Install the
display
assembly.
5. Install the
power
button.
6. Install the
power-button
7. Install the
IO
board.
8. Install the fan.
9. Install the
front speakers (4-cell battery)
10. Install the
4-cell battery (64 Wh)
11. Install the
coin-cell
battery.
12. Install the
wireless
card.
13. Install the
base
cover.
14. Follow the procedure in
board.
or
front speakers (6-cell
or
6-cell battery (87
After working inside your
battery), whichever applicable.
Wh), whichever applicable.
computer.
Removing and installing components
59
Advertisement
Table of Contents
