Table of Contents
Advertisement
S3
.
D. Rotate the Capstan Motor clockwise
slack tape as shown in
E. Rotate the Main Cam Gear counter-clockwise again
remove the cassette-tape as shown in
F. Set the Position Switch to EJECT POSITION certainly as shown
in
Fig. S10
G. Install the Loading Motor and tighten screw (S1) as shown in
Fig. S8
.
6.5.4. CYLINDER UNIT REPLACEMENT
NOTE:
Since securing of RT gap is impossible to be done outside the factory, do not replace only
replace the Upper Cylinder unit of R4 Mechanism, please replace the whole Cylinder Unit with a
Fig. S6
.
(Fig. S9
.
Fig. S9
Fig. S7
Fig. S10
20
) to remove the
(Fig. S9
.
) to
Advertisement
Table of Contents
