AEG SKE81221AC User Manual page 13

Problem
The compressor does not
start immediately after
pressing the "COOLMAT-
IC", or after changing the
temperature.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The COOLMATIC function is
switched on.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The "COOLMATIC function"
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
ENGLISH
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "COOLMATIC func-
tion".
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off "COOLMATIC
function" manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "COOL-
MATIC function".
Keep the OK button pressed
for approximately 10 sec-
onds until a long sound is
heard and display shuts off
for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
13