Table of Contents
Advertisement
•
Wait until the red LED goes off and the acoustic signal
another 3 s).
•
Release the RESET button.
The following network parameters will be set after restart:
•
IP address: 192.168.1.100
•
Network mask: 255.255.255.0
•
Default gateway: 192.168.1.1
Dynamic IP Address Setting
Follow the instructions below to switch on the Dynamic IP address mode (DCHP ON):
•
Press and hold the RESET button.
•
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal
can be heard (approx. 15–35 s).
•
Wait until the red LED goes off and the acoustic signal
another 3 s).
•
Wait until the green LED goes off and the red LED goes on again and the acoustic signal
can be heard (approx. for another 3 s).
•
Release the RESET button.
Installation manual 2N® IP Audio Kit
can be heard (approx. for
can be heard (approx. for
40 / 57
Advertisement
Table of Contents
