Table of Contents
Advertisement
Audio Kit and the nearest network element. Connect your 2N
LAN1 interface to supply it successfully.
Caution
•
In case you feed your 2N
power supply, monitor the power consumption of the whole system. With regard
to the PoE 802.3af capacities and efficiency of the switched-mode power supplies
in the device, the maximum possible device input is approximately 12 W. An
overload of the PoE source usually results in PoE disconnection and, subsequently,
®
2N
IP Audio Kit restart.
®
•
The 2N
switched on LED1–3 and OUT1–2 outputs) is up to 2 W.
•
The maximum power amplifier consumption is determined by the current
loudspeaker volume level and impedance (up to 10 W for a 4 Ω loudspeaker). The
real consumption is typically lower and depends on the characteristics of the
signal to be amplified.
•
If you intend to connect a considerable load to the OUT1 and OUT2 outputs, make
sure that the total input does not exceed the above mentioned limit (12 W for PoE).
If the PoE supply fails to provide sufficient power for the specific application, use a
more powerful external source to make your device work perfectly.
®
IP Audio Kit via PoE or from a limited-power external
IP Audio Kit consumption at relax (power amplifier inactive, no load
Installation manual 2N® IP Audio Kit
®
IP Audio Kit to the LAN via the
33 / 57
Advertisement
Table of Contents
