Table of Contents
Advertisement
Reset Button
Located among the main unit connectors, the Reset button helps you reset the factory default
values, restart the device, find the device IP address and switch the static/dynamic mode.
IP Address Finding
Follow the instructions below to identify the current IP address:
•
Press and hold the RESET button.
•
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal
can be heard (approx. 15–35 s).
•
Release the RESET button.
•
The device automatically announces the current IP address.
Note
•
The delay after pressing RESET till the first light and sound signalling is set to 15–
35 s depending on the 2N IP intercom/answering unit model used.
•
37 s is the valid value for 2N
Static IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DHCP OFF):
•
Press and hold the RESET button.
•
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal
can be heard (approx. 15–35 s).
Installation manual 2N® IP Audio Kit
®
IP Audio Kit.
39 / 57
Advertisement
Table of Contents
