Mac Faucets ADA Grab Bar Series User Manual

Installation Instructions
36" Grab Bar for ADA Application
42" Grab Bar for ADA Application
Important notes for proper Installation
DO NOT INSTALL this product without reading and understanding the warning instructions. If you are unable
to understand these warnings and instructions, contact professional or technical personnel for assistance-
otherwise injury may occur.
GRAB BAR LOCATION
For proper mounting heights and location, consult with your state and local code official, they have jurisdiction
over the installation
SOLID SUPPORT
* Grab Bar ends must be mounted with both end position over a wall stud. Stud finder must be used to locate
wall studs, Contractor is responsible for installing Grab Bar to wall studs as instructed.
* Secure through wallboard or tile to the wall so as to hold a minimum of 250 pounds.
* At least two (2) of the three (3) wood screws provided must be used on each end of the Grab Bar, top and
bottom, to properly secure Bar to wall. Standard size wall studs limit using more than two (2) wood screws.
* If using a drill to install wood screws, a drill bit extension must be used to avoid damaging the Grab bar.
Tools Needed
Safety Glasses
Mark The studs
Package Includes
Stainless Steel Construction
Concealed mounting for a clean look
1-1/4" bar diameter
2-1/2" flange diameter
Bar extends 1-1/2" from wall
Supports up to 250 lbs.
Meets ADA load requirements when properly installed
All hardware necessary for satisfactory installation
Level Cordless Drill
Drill bit
Ø 1/4" Carbide
Drill for tile
FOR SAFETY
01
REASONS, GRAB
BARS MUST
MOUNT TO STUDS
ONLY. With the stud
finder tool, locate
and mark position of
the studs.
Stud
Finder
User Manual
ADA Grab Bar Series
Models: GB-36 & GB-42
Stud Finder
Phillips Screw Driver
Unscrew flanges and pull back from the two ends of the
02
grab bar. Position the grab bar so that the mounting
ends are against the studs. Make sure the bar is leveled.
Mark drill hole locations.
Pencil
Level
PAGE | 01