HP Compaq dx7300 ST Hardware Reference Manual page 41

Business pc

Hide thumbs Also See for Compaq dx7300 ST:

Table of Contents

Align the rear guide screws with the rear J-slots on the drive cage and press down on the rear of

the drive (1), then slide the drive back until it locks into place (2).

Figure 2-28

Connect the appropriate drive cables:

If installing a diskette drive, connect the power and data cables to the rear of the drive and

connect the other end of the data cable to the connector on the system board labeled FLOPPY

P10.

If installing a second hard drive, connect the power and data cables to the rear of the drive

and connect the other end of the data cable to the next available (unpopulated) SATA

connector on the system board by following the numbered sequence of the connectors.

If installing a media card reader, install the PCI card included with the media card reader and

connect the USB cable from the media card reader to the USB connector on the PCI card.

Replace the optical drive.

ENWW

Installing a Drive into the 3.5-inch Drive Bay (Hard Drive shown)

Installing and Removing Drives

Table of Contents

Compaq dx7300 slim tower